NSPS for Stationary Gas Turbines (40 CFR Part 60, Subpart GG) (Renewal)
Extension without change of a currently approved collection
No
Regular
09/30/2025
Requested
Previously Approved
36 Months From Approved
09/30/2025
1,070
1,070
69,100
69,100
0
0
The New Source Performance Standards (NSPS) for Stationary Gas Turbines (40 CFR Part 60, Subpart GG) were promulgated on September 10, 1979; and last-amended on February 27, 2014. These regulations apply to both existing facilities and new facilities that have stationary gas turbines with a heat input at peak load equal or greater than 10.7 gigajoules per hour (based on the lower heating value of the fuel fired). There are no new facilities under this subpart, as any facility which commenced either construction, or modification, or reconstruction after February 18, 2005 is subject to the NSPS for Stationary Combustion Turbines (40 CFR Part 60, Subpart KKKK). This information is being collected to assure compliance with 40 CFR Part 60, Subpart GG.
In general, all NSPS standards require initial notifications, performance tests, and periodic reports by the owners/operators of the affected facilities. They are also required to maintain records of the occurrence and duration of any startup, shutdown, or malfunction in the operation of an affected facility, or any period during which the monitoring system is inoperative. These notifications, reports, and records are essential in determining compliance, and are required of all affected facilities subject to NSPS.
On behalf of this Federal agency, I certify that the collection of information encompassed by this request complies with 5 CFR 1320.9 and the related provisions of 5 CFR 1320.8(b)(3).
The following is a summary of the topics, regarding the proposed collection of information, that the certification covers:
(i) Why the information is being collected;
(ii) Use of information;
(iii) Burden estimate;
(iv) Nature of response (voluntary, required for a benefit, or mandatory);
(v) Nature and extent of confidentiality; and
(vi) Need to display currently valid OMB control number;
If you are unable to certify compliance with any of these provisions, identify the item by leaving the box unchecked and explain the reason in the Supporting Statement.